Guitar Build Update: Finishing The Envirocaster Part 1

After sanding the body to 220 grit, I filled the grain with some neutral
Timber Mate mixed with water.

I brushed two coats of the soupy mixture over the entire body
and allowed two hours of dry time between coats.

After the Timber Mate had been allowed to fully dry, I sanded off the
excess with 220 grit paper.

Next, I vacuumed off the dust and brushed on a couple of coats of
water-based lacquer thinned 1:1 with water. This layer of lacquer will
seal the surface and prepare it for the next step.

In part 2 of the finishing process, I will lightly sand the body with 220 grit and apply a brown burst around the edge. Stay tuned!